Here are the steps to stretching your paper

  • An alternative method is to staple the paper down onto the board if you do not wish to use gummed brown tape. Put them all to one side for the moment once you have cut them.

    Step 5. Still want to learn to paint? Read the next tip for some more help. Here are the steps to stretching your paper:

    Step 1. This will lead to an unsatisfactory result for you. The board must be lying completely flat. Very gently shake off the excess water from it and then place it upon the drawing board. The paper will stay flat when you use it. You might think that this is not the case because you are going to make moisten it again when you paint on to it. It needs to be away from any direct heat source. That way you will not run the risk of getting gum on your sheet of watercolor paper. Do not soak it for too long, either, for the same reason.

    . Do this for about two minutes and allow the fibers in the paper to expand.

    Step 2. The good news is that it is a pretty straightforward process and one you can do yourself. Sizing is always added to watercolor paper to reduce its absorbency so you want it to stay there.

    You will need only a few things to get started. This prepares the paper for the stretch. Take one of the strips of gummed paper tape and moisten it. Read the rest of this article to learn how to do it properly.

    Step 3. Take a clean sponge and smooth out the paper.

    Try to use a different color sponge for smoothing the piece of paper and moistening the gummed tape. This is because it could remove the sizing from the paper. The problem is that paper of less than 260 lb (356 gsm) needs to be stretched before you use it otherwise it will simply warp if you do not do so. You can try using your fingers, aluminum bending if you wish, but make absolutely certain that they are clean and have no grease on them. It is very tempting to get right on with the process of creating your next masterpiece but the truth is that it is well worth spending some time stretching your watercolor paper. Work your way around all of the other sides of the sheet of paper in the exactly same fashion. Make sure that you keep the drawing board flat while the paper dries. Now leave the paper alone to dry for several hours.

    Step 9. They are:

    * A couple of sponges

    * Some watercolor paper

    * A drawing board

    * Gummed brown paper tape

    Remember, if you want to learn to paint you need to know how to do this procedure.

    There are some more tips to bear in mind as you learn to paint:

    Avoid using hot water to soak your watercolor paper. The water will drain to one or other edge if you do not and the paper will drive unevenly. Take the sheet of paper and lift it.

    Step 4. You must get the paper perfectly flat and smoothed at this stage in order for it to be smooth once it is dry. Get some more help from the next step as you learn to paint

    Step 7. Make sure that it is firmly attached. This technique ensures that the paper is fastened soundly to the board and that it will not be pulled off the board as it dries.Learn to paint the right way by reading this article. However, the aluminum laser cutting paper will never again be as damp as it was in step 2 so it will actually stay nice and flat for you.

    Step 8. You want to stick the tape so that two-thirds of the tape is on the board and that one third is on the paper.

    Step 6. The fibers in the paper contract as the water evaporates leaving the sheet of watercolor paper smooth and flat. Soak the sheet of paper in cold water. Stick it along one edge of the paper. It will serve you well. Take four strips of gummed brown tape, that is one for each edge of the paper, and cut them slightly longer than the sides to which they will be attached. You should remember this as you learn to paint